Cannon VB-C500VD Guide d'installation télécharger pdf (Page 130)

5-4

Troubleshooting

Before contacting your store or Canon's Customer Service Center, check the items specified

below. If a log message is displayed, check the details of the message and corresponding

countermeasure in the log message list.

The camera does not start

z If you are using a PoE HUB, check if the LAN cable is connected correctly.

z If you are using an AC adapter (optional), check if the AC adapter is connected correctly.

z Reconnect the power. See "Connect the Camera to the Network and Turn on the Power "

(Start Guide).

VB Initial Setting Tool does not operate

z Check if the LAN cable is connected correctly.

z See "Connect the Camera to the Network and Turn on the Power" ( Start Guide), and try

reconnecting the camera power. VB Initial Setting Tool will stop responding after 20 minutes

of turning on the power.

z Check if the camera and the PC in which VB Initial Setting Tool is operating are connected

to the LAN in the same segment.

z The VB Initial Setting Tool may not function when the [Windows Firewall] function is

enabled. In this case, see "Notes on Use When the [Windows Firewall] Function is Enabled"

( Start Guide).

z Check if you are using an older version of VB Initial Setting Tool.

The top page of the camera is not displayed

z Check if the LAN cable is connected correctly.

z Check if the network to which the camera is connected is set up correctly. In particular,

check if the IP address, subnet mask and default gateway address are set within the

ranges supported by the applicable network.

z If you have changed the IP address, the new address will not become effective until the

camera is rebooted.

z Check if the correct URI (IP address of the camera) has been entered in the web browser

( P. x, P. 3-6, P. 4-2).

COPY

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 159 160

Pas de commentaire

Cannon VB-C500VD Guide d'installation Page 130