Cannon Mag 20 Dt/Hs Guide d'installation télécharger pdf (Page 36)

Fishing System Defaults to Simulator

with a Transducer Attached

A connected and functioning transducer will cause the newly-started Fishing

System to go into Normal operating mode automatically. If, when you power

up the Fishing System, it goes into Simulator mode automatically, even though

a transducer is already connected, this means that the control head is not

detecting the transducer. Perform the following troubleshooting tasks:

• Using the Installation Guide that also comes with your Fishing System,

check to make sure that the transducer cable is securely connected to

the Fishing System. Reconnect if necessary, and power up the Fishing

System again to see if this fixes the problem.

• Replace the non-functioning transducer with a known good transducer

if available and power up the control head again.

• Check the transducer cable. Replace the transducer if the cable is

damaged or corroded.

Troubleshooting

1 2 ... 31 32 33 34 35 36 37 38 39

Pas de commentaire

Cannon Mag 20 Dt/Hs Guide d'installation Page 36